Industrial Electronics

EPC - Install on existing fire alarm system a new carbon monoxide detector in mechanical 021. Install Monitor Modules to monitor new carbon monoxide detector and co power.

EPC - REPLACE AN EXISTING FIRE ALARM SYSTEM WITH A COMPLETE NEW FIRE ALARM SYSTEM. INSTALL NOTIFICATION APPLIANCES THROUGHOUT ALL WAREHOUSE AND OFFICE AREAS. INSTALL A PULL STATION AND ANNUNCIATOR AT THE MAIN ENTRY. MONITOR EXISTING FIRE SPRINKLER SYSTEM INCLUDING VALVE TAMPERS, WATER FLOW SWITCHES, BACKFLOW PREVENTER, P.I.V., AND FIRE PUMP EQUIPMENT. MAINTAIN THE EXISTING ELEVATOR INTERFACE EQUIPMENT FOR RECALL AND DETECTION, COORDINATE WITH SITE CONDITIONS. INSTALL SMOKE DETECTION WHERE INDICATED FOR ELEVATOR RECALL, ABOVE ALL POWER SUPPLIES AND ABOVE THE FACP. MONITOR THE EXISTING KITCHEN HOOD ANSUL SYSTEM. RE-USE EXISTING PATHWAY AND CABLING WHERE AVAILABLE. INSTALL NEW CABLE TO NEW LOCATIONS AS NEEDED.

On an existing fire alarm system replace an existing aspiration smoke detector with a new vesda addressable aspiration detector. All CPVC aspiration piping is existing and to be reused. System has been designed to utilize all existing CPVC aspiration piping and sampling ports without reconfiguring air- sampling pipes

On an existing fire alarm system modify the fire alarm devices un the new storage expansion. Relocate (1) existing notification devices. install (2) two new notification devices

EPC - Install a new notification power supply on an existing fire alarm and install notification appliances throughout Local 46 building areas.

EPC - Install relay modules on an existing fire alarm system for the building's elevator modernization project.

Install additional notification appliances through out the data center floor in areas that are noted to have deficient notification coverage during recent fire alarm inspections. Key map is located on sheet FA-002 which shows all the specific areas, noted in the inspection report, that require additional audible and visible notification.

Install additional notification appliances through out the data center

EPC - Install duct smoke detectors to an existing fire alarm system and relay modules for Outside Air Fan shutdown.

Install new horn/strobe device and 2 heat detectors in the new conex trailer. Pull new wire from closes existing devices to add new devices to existing circuits

Modify the FA devices in the new storage expansion.

INSTALL A CELLULAR COMMUNICATION TO AN EXISTING ONE

install a cellular communication to an existing one

EPC - To install a new sprinkler monitoring system in the existing building. Remodel permit under COM-1920232

Modify the FA devices in the new storage expansion.

Removing and replacing duct smoke detector and relay modules

EPC - Installation and programming of fire alarm relay to existing fire alarm panel ONLY

Adding (3) notification devices on existing Circuits-Corrective Action in Response to Annual Fire Inspection

Lutheran Church - Fire Alarm System Upgrade for radio communication and elimination of telephone lines at the fire alarm control panel.

Install new fire alarm and elevator control system

Install a new fire alarm control panel with internal dialer to replace existing panel

Replace existing VOIP telecom lines with new cellular dialer communicator.

FIRE ALARM UPGRADE/ REPLACEMENT

Installation of a new cellular alarm communicator to the existing fire alarm system (Fire System 100 sf)

EXPEDITED - EPC - 1150 sf first-time tenant improvement for Metro PCS - Add 8-ft partition 2 ft below ceiling level to finished shell space, cabinets and shelving. No work to electrical, mechanical or plumbing.